Regulatory Status and Context
BS 7671:2018+A2:2022 (The Brown Book) was published on 28 March 2022 and took mandatory effect on 27 September 2022, representing the second major revision of the 18th Edition. It absorbed Amendment 1:2020 and established comprehensive rules for modern electrical safety, fire prevention, and renewable integration.
BS 7671 is a non-statutory national standard that is given legal weight through explicit citations in statutory instruments, including the Electricity at Work Regulations 1989 (via HSE Memorandum HSR25), the Electrical Safety Standards in the Private Rented Sector (England) Regulations 2020, and Approved Document P of the Building Regulations.
Under the non-retrospective doctrine of BS 7671, an existing installation that complied with earlier standards at the time of construction is not considered unsatisfactory simply because a newer edition exists. However, duty holders remain under a continuous legal duty under EAWR 1989 Regulation 4(1) (to construct systems to prevent danger, so far as is reasonably practicable) and Regulation 4(2) (to maintain systems to prevent danger, so far as is reasonably practicable).
Key Technical Changes
1. Arc Fault Detection Devices (AFDDs)
Regulation 421.1.7 made AFDDs conforming to BS EN 62606 mandatory for AC final circuits supplying socket-outlets up to 32A in specific high-risk locations:
- Higher-Risk Residential Buildings (HRRBs) 18 metres or more in height or at least 7 storeys, with two or more residential units.
- Houses in Multiple Occupation (HMOs).
- Purpose-built student accommodation.
- Care homes.
For all other premises, the use of AFDDs is recommended for AC final circuits supplying socket-outlets up to 32A.
2. Transient Overvoltage Protection (SPDs)
Regulation 443.4.1 was revised to remove the previous calculated risk assessment formula based on the CRL calculation. Instead, protection against transient overvoltages via SPDs is mandatory where the consequence could result in:
- Serious injury to, or loss of, human life;
- Failure of a safety service, as defined in Part 2;
- Significant financial or data loss.
For all other cases, protection against transient overvoltages shall be provided unless the owner of the installation declares in writing that it is not required on economic grounds. In commercial, industrial, or communal premises, statutory health and safety duties under EAWR 1989 and the Health and Safety at Work etc. Act 1974 mean that economic declarations cannot waive protection where safety-critical risks or failure of safety services exist.
3. Residual Current Device Types
Regulation 531.3.3 clarified that Type AC RCDs must only be selected for circuits where the load current is purely sinusoidal with no residual DC components. Because modern appliances, computers, washing machines, and electronic power supplies produce DC residual currents, Type A RCDs became the standard default selection for domestic and commercial final circuits. Type F RCDs are specified for circuits supplying single-phase variable-speed drives (such as heat pumps and inverter drives), while Type B RCDs are required where three-phase rectification or smooth DC residual currents can arise.
4. Chapter 82: Prosumer Electrical Installations
Part 8 introduced Chapter 82 to govern Prosumer Electrical Installations (PEIs). It provided guidelines for systems with local generation and energy storage, defining operating modes: individual installation, collective installation, and shared installation, together with requirements for islanding and grid synchronisation.
On this site: review our guides on RCD type selection (Type AC obsolescence), AFDD installation and tripping guidance, and mandatory SPD requirements.
Timeline
Authoritative Sources
- IET Wiring Matters: Complete Guide to BS 7671:2018+A2:2022
- IET BS 7671 Updates: Archive and Errata
- Electrical Safety First: Best Practice Guides (BPG4 Issue 5)
This archive page reports what changed and when, with verified sources. It does not replace competent engineering judgement. Always work from the published standard and manufacturer technical datasheets.